Get an estimate
Two quick steps. A Redmond-based comfort advisor will call you to set up your visit.
- Serving Puget Sound homeowners since 1977
- 4.8 stars from 5,000+ reviews
- Licensed, bonded and insured in Washington
- PSE Trade Ally contractor
- Energy Smart Eastside approved contractor
- WA Contractor Reg. #HOMECCA785BD
Heating repair and service in Issaquah, WA
Our Redmond branch sends heating technicians to Issaquah homes to repair and maintain gas furnaces, electric furnaces, heat pumps, dual-fuel systems and ductless mini-splits. Call (425) 645-0404 or use the form, and a comfort advisor will book the visit.
A large share of Issaquah’s homes are 10 to 30 years old, so many furnaces and heat pumps are the originals installed with the house. Many are now at the age where repairs become more frequent and a replacement plan makes sense. Puget Sound Energy supplies both gas and electricity here.
Typical heating repair costs
Seattle-area data puts most furnace repairs between $139 and $544, averaging about $341, with major repairs reaching about $2,000 (Angi, Seattle furnace repair costs, updated August 2026). These are published estimates, not our prices. After diagnosis you get a written price, and nothing proceeds until you approve it.
High-efficiency furnace problems we see
Newer Issaquah homes are more likely to have 90 percent or higher efficiency gas furnaces. They save gas, but they have parts older furnaces do not, and those parts account for many winter calls:
| Symptom | Common cause |
|---|---|
| Furnace starts, then shuts off | Blocked condensate drain or trap, or a failed pressure switch |
| No heat, clicking or error code | Dirty flame sensor, failed hot surface ignitor, or inducer motor |
| Water around the furnace | Cracked condensate line, full pump, or clogged drain |
| Furnace runs but air is lukewarm | Clogged filter, dirty coil or duct restriction |
| PVC vent frosting or blocked | Snow, leaves or nests at the outside vent terminal |
Check the outdoor PVC intake and exhaust pipes after storms. A blocked vent shuts the furnace down to protect the house, and clearing it often restores heat.
Heat pump service
Heat pumps are common in newer Issaquah construction and in homes that have already converted. We repair ducted and ductless heat pumps: failed capacitors and contactors, refrigerant leaks, defrost faults, stuck reversing valves, fan motors, and backup heat strips that stop working. Outdoor units on shaded, wet north slopes pick up moss and debris, so keep two feet clear around them. A heat pump that blows cool air briefly in winter is usually just defrosting; one that blows cool air for long stretches, or runs constantly on backup heat, needs a service call.
Switching to a heat pump in Issaquah
If repairs are adding up, Issaquah homeowners have more help than most for switching. The city is part of Energy Smart Eastside, which offers $1,000 for qualifying Mitsubishi, Bryant/Carrier or Day & Night heat pumps installed by an approved contractor, and a bonus of up to $5,000 for moderate-income households going fully electric (Energy Smart Eastside, heat pump incentives). PSE rebates can apply as well: $1,500 plus up to $2,400 more when replacing electric resistance heat, or $1,500 plus up to $2,400 for adding a heat pump to a PSE gas furnace (PSE electric resistance to heat pump rebate; PSE hybrid heat pump rebate). Home Comfort Alliance is an Energy Smart Eastside approved contractor and a PSE Trade Ally. See our Issaquah heat pump page for details.
Repair or replace?
A repair usually makes sense for a system under about 15 years old with a good track record. Consider replacement when:
- The furnace or heat pump is 15 to 20 years old and needs a major component.
- Breakdowns have become a yearly event.
- A cracked heat exchanger or venting defect has been found.
- You want to cut heating costs or add cooling, and rebates make a heat pump affordable.
We lay out both options with prices. If replacement is the better call, see our Issaquah furnace replacement page.
Uneven rooms on hillside and multi-level homes
Split-level and daylight-basement homes built into Issaquah’s slopes often have one level that is too warm and another that is too cool. The causes are usually airflow, not the furnace: long duct runs, a single return, or a thermostat on the wrong floor. Fixes include balancing dampers, an added return, sealing and insulating ducts, zoning with a second thermostat, or a ductless head for the level that never keeps up. We measure room temperatures and airflow first, so you pay for the fix that addresses the actual cause rather than a larger furnace that will not solve it.
Thermostats and controls
A surprising number of heating calls end at the thermostat: dead batteries, a loose wire, a schedule that fights the household, or a smart thermostat installed without the common wire it needs. With heat pumps, settings matter even more. Deep night setbacks can trigger expensive backup heat every morning, and the wrong system type setting can stop the heat pump from heating at all. We check wiring and configuration, update schedules, and replace thermostats with models that suit your system, including two-stage and variable-speed equipment.
Winter air: filters, moisture and comfort
With all the rain Issaquah gets, homes here rarely suffer from dry air the way homes east of the mountains do. More often the issue is the opposite: condensation on windows, musty basements and stale air in tightly built newer homes. Heating season is a good time to:
- Upgrade to a deeper pleated filter cabinet for better filtration with less airflow restriction.
- Check that bath and kitchen fans actually vent outdoors.
- Make sure ventilation systems in newer, tighter homes are running and their filters are clean.
- Look for crawlspace or basement moisture that raises indoor humidity.
On a heating call
Your advisor books a window and notes the symptoms and any error code the furnace is flashing. The technician checks the system while it runs, measuring gas pressure, electrical readings, temperature rise and, on heat pumps, refrigerant pressures, then explains what failed and why. You get repair options in writing; if replacement is worth considering, those numbers are on the same sheet. After the repair, the system is run through a full cycle and gas equipment gets a carbon monoxide check.
Fall maintenance
- Inspect burners, ignitor and flame sensor; clean as needed.
- Test safety controls and measure carbon monoxide at the flue.
- Flush the condensate trap and drain on high-efficiency furnaces.
- Check blower motor, capacitor and airflow.
- On heat pumps, check refrigerant pressures, defrost and backup heat.
- Replace the filter and verify thermostat settings.
Permits and safety
Replacing a furnace or adding a heat pump in Issaquah generally needs a mechanical permit from the City of Issaquah Permit Center; new wiring needs an L&I electrical permit (City of Issaquah, Do I Need a Permit?; City of Issaquah, electrical permits). Like-for-like repairs do not. Every gas appliance we work on gets a combustion and carbon monoxide check before we leave. If a carbon monoxide alarm sounds, get everyone outside and call 911, then PSE, before calling us.
Warranty and Home Comfort Club
We support the manufacturer’s warranty on covered equipment parts, and we stand behind our heating installations with a 1-year labor warranty from installation.
Join our Home Comfort Club, a monthly membership starting at $15 a month, and the labor warranty on repairs is extended for as long as your prepaid membership runs, up to 5 years from installation. Ask your technician or comfort advisor for the current plan details.
Issaquah heating FAQ
How much does furnace repair cost in Issaquah?
Seattle-area data puts most furnace repairs between $139 and $544, about $341, with larger repairs up to about $2,000 (Angi, August 2026). We give a written price after diagnosis.
Why does my high-efficiency furnace keep shutting off?
A blocked condensate drain, a failed pressure switch or a blocked PVC vent are the most common causes. A technician can test each.
Is there a heat pump incentive in Issaquah?
Yes. Energy Smart Eastside offers $1,000 for qualifying heat pumps through approved contractors, plus up to $5,000 for moderate-income households, and PSE rebates may also apply.
Do I need a permit to replace a furnace in Issaquah?
Generally yes: a mechanical permit from the City of Issaquah, plus an L&I electrical permit if wiring changes. We handle both.
How often should heating be serviced?
Once a year, ideally in early fall. Heat pumps that also cool benefit from a spring visit.
Why does my heat pump run on backup heat every morning?
Usually a large overnight setback. The heat pump cannot recover fast enough, so strips come on. Smaller setbacks or a smart recovery setting usually fix it.
What warranty comes with your work?
We support the manufacturer’s warranty on covered equipment parts, and our labor warranty covers installations for 1 year from installation. Home Comfort Club members (monthly membership starting at $15 a month) get the labor warranty on repairs extended for as long as their prepaid membership runs, up to 5 years from installation.
Get a heating estimate in Issaquah
A Redmond-based comfort advisor will set up your visit, and our technician will give you a written price before any work starts.
Get an estimateCall (425) 645-0404Why Choose Home Comfort Alliance in Issaquah?
Your Comfort is Our Promise
We promise...
Reliable heating, air conditioning, plumbing and electrical service, all from one trusted company.
To educate and guide you through your options so you’ll find the right solution at the right price.
Knowledgeable and respectful workers who ensure both your own comfort during the installation process, and lasting comfort from your home systems.
Outstanding service, communication, and follow-up, so your home is comfortable now and for years to come.
