Locally-owned since 1977 • Licensed, bonded and insured in Washington (WA Contractor Reg. #HOMECCA785BD) • WA Electrical Contractor Lic. #HOMECCA782DC • NATE-certified technicians • Carrier Factory Authorized Dealer
Electrician in Federal Way, WA
Our licensed electricians repair faulty circuits, replace and upgrade panels, add circuits for heat pumps and EV chargers, and install standby generators for Federal Way homes. They work out of our Sumner branch; call (425) 645-0404 or send the form, and a coordinator will schedule the visit. You get a written price and a permit plan before any work starts.
Federal Way sits along I-5 in south King County, a short drive from our Sumner branch. Puget Sound Energy supplies the city’s electricity (City of Federal Way, Who Do I Contact).
Electrical prices around Federal Way
The ranges below are published national estimates, not our prices. After we inspect the job, you get a written quote.
| Work | Range |
|---|---|
| Service visit | $163 to $538, typically about $351 |
| Hourly rate | $50 to $130 |
| New outlet | $200 to $300 |
| Ceiling fan | $140 to $350 |
| Panel (breaker box) replacement | $500 to $1,800 |
| Whole-home rewiring | $1,500 to $10,000 |
Source: Angi, electrician costs, updated August 2026.
Get an estimateA comfort advisor will call you to set up your visit.
Federal Way runs its own electrical inspections
In most Washington cities, L&I issues electrical permits and sends the inspector. Federal Way is one of the exceptions: the city issues its own electrical permits and inspects the work itself (L&I, cities that do their own electrical permits). Residential electrical permits are filed through MyBuildingPermit, the online portal the city uses for electrical, mechanical and plumbing permits (City of Federal Way, Permit Center).
For you, that means the permit and the inspection both come from the City of Federal Way, not the state. We file the permit, book the city inspection and meet the inspector, so the work is signed off and on record.
Panels in homes built before 1990
Many Federal Way neighborhoods are decades old. Homes from that era often have 100 amp service or less, panels with no open spaces, and wiring that was never meant to carry a heat pump, an induction range and an EV charger at the same time. Some older panels, including certain Federal Pacific and Zinsco models, have a record of breakers that may not trip when they should.
Signs your panel needs attention:
- Breakers that trip often, or feel warm to the touch.
- Double-tapped breakers or no room for a new circuit.
- Rust inside the panel, or a burning smell near it.
- Lights that dim when the furnace blower or a large appliance starts.
We run a load calculation, then give you written options: a panel replacement, a service upgrade to 200 amps, or a load management device when the service itself is large enough.
EV chargers at Federal Way homes
A Level 2 charger runs on a dedicated 240 volt circuit, usually 40 to 60 amps. In a garage near the panel it is a straightforward install; a long run to a driveway or a condo parking space takes more planning. If you park outside, the charger can go on an exterior wall or a post, as long as it is rated for outdoor use and the circuit is protected along its whole run. Tell us which vehicle you drive and how far you commute, and we will suggest a charger size that fits. We check your panel capacity first, then give you a written price for the circuit, the charger mounting and the city permit.
Circuits for heat pumps and air conditioning
Replacing electric baseboards or a wall heater with a heat pump is one of the most common upgrades in Federal Way, and PSE offers rebates for it (PSE electric resistance to heat pump rebate). The outdoor unit needs its own circuit and a disconnect beside it. Because our electricians and HVAC technicians work for the same company, the circuit, the disconnect and the equipment are installed and inspected as one job.
Standby generators and outages
Windstorms can bring down lines across south King County, and a long outage in winter means no heat, a cold fridge and, for homes on a sump pump, a flooded crawlspace. A standby generator with an automatic transfer switch restarts the circuits you choose within seconds. We size the generator to your loads and install it under a city electrical permit. Portable generators should only connect through a transfer switch or interlock, never by backfeeding a dryer outlet.
Salt air along the shoreline
Homes near Dash Point and Redondo sit right on Puget Sound. Salt air corrodes outdoor meter bases, disconnects, outlets and fixture connections faster than it does inland. If you live near the water, we check outdoor gear for corrosion and use weather-resistant covers and devices outside.
Rentals and safety upgrades
Plenty of Federal Way homes are rentals. We coordinate access with the tenant and send the written price to the owner. Common safety updates include GFCI protection in kitchens, baths and outdoors, AFCI breakers, hardwired smoke and carbon monoxide alarms, and replacing ungrounded outlets.
Lighting, outlets and everyday repairs
Not every call is a big project. We replace dead outlets and switches, add outlets where extension cords have taken over, install ceiling fans and recessed lights, put in dimmers and exterior lighting, and track down circuits that stopped working for no clear reason. We diagnose first and give you the price in writing before we fix anything.
When to call an electrician right away
- A burning smell, scorch marks or heat at an outlet, switch or panel.
- A breaker that trips again as soon as you reset it.
- Flickering lights across the house, which can point to a loose service connection; call PSE if the problem is at the meter or overhead line.
- Any outlet or fixture that has been wet from a leak or flood.
If you see sparks or smoke, turn off the main breaker if it is safe to reach and call 911.
How our electricians work
Home Comfort Alliance holds WA Electrical Contractor Lic. #HOMECCA782DC and is licensed, bonded and insured in Washington. Our electricians explain what they find, give you a written price, pull the permit the job needs and clean up before they leave. See our residential electrical services or all Federal Way services.
Warranty and Home Comfort Club
We support the manufacturer’s warranty on covered equipment parts, and we stand behind our electrical installations with a 1-year labor warranty from installation.
Join our Home Comfort Club, a monthly membership starting at $15 a month, and the labor warranty on repairs is extended for as long as your prepaid membership runs, up to 5 years from installation. Ask your technician or comfort advisor for the current plan details.
Federal Way electrical FAQ
How much does an electrician cost in Federal Way?
National data puts a typical electrician visit between $163 and $538, about $351, with panel replacements from $500 to $1,800 (Angi, electrician costs, updated August 2026). These are published estimates; you get a written price from us before work starts.
Who inspects electrical work in Federal Way, the city or L&I?
The city. Federal Way is on L&I’s list of cities that issue their own electrical permits and perform their own inspections (L&I, cities that do their own electrical permits). Residential electrical permits can be filed online through MyBuildingPermit (City of Federal Way, Permit Center).
Do I need a bigger panel for a heat pump or EV charger?
Not always. We run a load calculation on your existing service first. Many homes with 100 amp service can add one large circuit; adding both a heat pump and a Level 2 charger often calls for a 200 amp upgrade or a load management device.
Who do I call when the power is out in Federal Way?
Puget Sound Energy supplies electricity in Federal Way (City of Federal Way, Who Do I Contact). Report outages to PSE. If only part of your home is dark, or a breaker keeps tripping, call an electrician.
Can you install a standby generator?
Yes. We size the generator to the circuits you want to keep running, install the transfer switch and connect it to your panel under a city electrical permit.
Are you licensed for electrical work in Washington?
Yes. Home Comfort Alliance holds WA Electrical Contractor Lic. #HOMECCA782DC and is licensed, bonded and insured in Washington.
What warranty comes with your work?
We support the manufacturer’s warranty on covered equipment parts, and our labor warranty covers installations for 1 year from installation. Home Comfort Club members (monthly membership starting at $15 a month) get the labor warranty on repairs extended for as long as their prepaid membership runs, up to 5 years from installation.
Why Choose Home Comfort Alliance in Federal Way?
Your Comfort is Our Promise
We promise...
Reliable heating, air conditioning, plumbing and electrical service, all from one trusted company.
To educate and guide you through your options so you’ll find the right solution at the right price.
Knowledgeable and respectful workers who ensure both your own comfort during the installation process, and lasting comfort from your home systems.
Outstanding service, communication, and follow-up, so your home is comfortable now and for years to come.
Get an electrical estimate in Federal Way
A Sumner-based coordinator will book a licensed electrician, and you get a written price and permit plan before work starts.
Get an estimate
A Sumner-based comfort advisor will call you to set up your visit.