Locally-owned since 1977 • Licensed, bonded and insured in Washington (WA Contractor Reg. #HOMECCA785BD) • WA Electrical Contractor Lic. #HOMECCA782DC • NATE-certified technicians • Carrier Factory Authorized Dealer
Electrician in Des Moines, WA
Our licensed electricians troubleshoot dead circuits and tripping breakers, replace and upgrade panels, wire heat pumps and EV chargers, and install generators for Des Moines homes. Des Moines work is booked through our Sumner branch at (425) 645-0404 or the form, and the electrician lays out the price and the permit steps in writing before starting.
Electricity in Des Moines comes from Puget Sound Energy (City of Des Moines, Community Services Directory), and the city handles its own electrical permits and inspections, which shapes how every job here is scheduled.
Electrical prices around Des Moines
Published national estimates, not our prices. You get a written quote once we have looked at the job.
| Work | Range |
|---|---|
| Service visit | $163 to $538, typically about $351 |
| Hourly rate | $50 to $130 |
| New outlet | $200 to $300 |
| Ceiling fan | $140 to $350 |
| Panel (breaker box) replacement | $500 to $1,800 |
| Whole-home rewiring | $1,500 to $10,000 |
Source: Angi, electrician costs, updated August 2026.
Get an estimateA comfort advisor will call you to set up your visit.
Permits and inspections come from the city
Des Moines is on L&I’s short list of cities that issue their own electrical permits and send their own inspectors (L&I, cities that do their own electrical permits). Residential electrical permits are filed through MyPermits Online, the same portal the city uses for building, plumbing and mechanical work (City of Des Moines, permit applications and information). We file the permit, book the inspection and meet the inspector, so you get work that is signed off by the city and on record when you sell.
Older panels on the hill
Many of the ramblers and split-levels between downtown and Pacific Highway still run on 100 amp service or less, with panels that are full and circuits that were never sized for today’s kitchens, heat pumps and chargers. Some older panel brands, including certain Federal Pacific and Zinsco models, have a history of breakers that may not trip when they should.
Signs your panel needs a look:
- Breakers that trip a lot or run warm to the touch.
- No open slots, or two wires under one breaker screw.
- Rust or water stains inside the panel, common in damp garages and basements.
- Lights that dim when the furnace or dryer starts.
We run a load calculation first, then give you written options: a new panel, a 200 amp service upgrade, or a load management device if the service is big enough.
Salt air and outdoor wiring
If your house looks out over the Sound, its outdoor electrical gear takes a beating. Salt air corrodes meter bases, disconnects, outlet covers and deck lighting faster than it does a mile inland. We check outdoor connections for corrosion when we work near the water, replace rusted boxes and covers with weather-resistant ones, and make sure outdoor outlets have working GFCI protection.
EV chargers in houses and condos
In a house with a garage near the panel, a Level 2 charger on a 40 to 60 amp circuit is usually a one-day job. Condos and apartments near the marina and along Pacific Highway are harder: the parking space may be far from the unit’s panel, and the HOA usually has to sign off. We map the route, check the panel capacity and give you a written plan you can take to the board.
Power for heat pumps and quieter homes
North of downtown, under the Sea-Tac flight path, plenty of homeowners keep windows shut to cut the noise, and that makes cooling more important. Adding a heat pump or ductless system means a new circuit and an outdoor disconnect. Our electricians and HVAC technicians work for the same company, so the circuit, the equipment and both inspections are planned as one project. PSE also offers rebates when a heat pump replaces electric heat (PSE electric resistance to heat pump rebate).
Generators and sump pumps
Winter windstorms can knock out power across south King County. On a hillside lot, the bigger worry is often the sump pump: if it stops during a storm, the crawlspace or basement can flood. A standby generator with an automatic transfer switch keeps the circuits you choose running; a generator inlet and interlock is a lower-cost way to run a portable unit safely. Never backfeed a generator through a dryer outlet.
Everyday repairs and upgrades
We replace dead outlets and switches, add outlets and circuits, hang ceiling fans, install recessed and exterior lighting, add dimmers, and fix circuits that quit for no clear reason. The cause gets found first; the fix gets priced in writing before anything is replaced.
Safety updates for older homes and rentals
A few upgrades make an older house or rental noticeably safer: GFCI protection in kitchens, baths, garages and outdoors; AFCI breakers on bedroom circuits; hardwired smoke and carbon monoxide alarms that sound together; and grounded outlets in place of two-prong ones. If you are selling, buying or getting a rental ready, we can price these as one visit.
Lighting for decks and view rooms
View homes spend a lot of time looking out, and the lighting often has not kept up. We add low-glare deck and stair lighting, exterior fixtures rated for wet locations, dimmers so a room does not reflect in the window at night, and switched outlets for seasonal lights.
When to call right away
- Burning smell, heat or scorch marks at an outlet, switch or panel.
- A breaker that snaps off again the moment you reset it.
- Flickering across the whole house, which can mean a loose service connection; call PSE if the problem is at the meter or the line.
- Outlets or lights that got wet from a leak or flood.
Smoke or sparks: kill the main breaker only if you can reach it safely, and call 911.
How our electricians work
Electrical work is done under WA Electrical Contractor Lic. #HOMECCA782DC by a company that is bonded and insured in Washington. You get an explanation, a written price and the permit, and the work area is left clean. See our residential electrical services or all Des Moines services.
Warranty and Home Comfort Club
We support the manufacturer’s warranty on covered equipment parts, and we stand behind our electrical installations with a 1-year labor warranty from installation.
Join our Home Comfort Club, a monthly membership starting at $15 a month, and a new system we install gets extended labor coverage for as long as your membership stays active, up to 5 years from installation. Ask your technician or comfort advisor for the current plan details.
Des Moines electrical FAQ
What does electrical work cost in Des Moines?
Published national figures put a service call at $163 to $538 (about $351) and a breaker panel swap at $500 to $1,800 (Angi, electrician costs, updated August 2026). Your price comes in writing once we see the job.
Does Des Moines or L&I inspect electrical work?
Des Moines does. It is one of the Washington cities that issue their own electrical permits and inspect the work (L&I, cities that do their own electrical permits), and permits are filed through the city’s MyPermits Online portal (City of Des Moines, permit applications and information).
Can I add an EV charger to a condo parking space?
Often, yes, but it takes more planning than a garage install. The circuit may need to come from a house panel or a common meter, and the HOA usually has to approve it. We look at the route and the panel capacity and give you a written plan you can take to the board.
Who do I call when the power goes out in Des Moines?
Puget Sound Energy supplies electricity in Des Moines (City of Des Moines, Community Services Directory); report outages to PSE. If only part of your home is out, or a breaker will not reset, call an electrician.
What size generator does a hillside home with a sump pump need?
It depends on which circuits you want to keep running. A small standby unit or a portable generator on an interlock can run a sump pump, the fridge, lights and a gas furnace blower. We size it after listing the loads with you.
Who holds the electrical license?
Our work is done under WA Electrical Contractor Lic. #HOMECCA782DC, and the company is bonded and insured in Washington.
What warranty comes with your work?
We support the manufacturer’s warranty on covered equipment parts, and our labor warranty covers installations for 1 year from installation. Home Comfort Club members (monthly membership starting at $15 a month) with a new system installed by Home Comfort Alliance get extended labor coverage for as long as their membership stays active, up to 5 years from installation.
Why Choose Home Comfort Alliance in Des Moines?
Your Comfort is Our Promise
We promise...
Reliable heating, air conditioning, plumbing and electrical service, all from one trusted company.
To educate and guide you through your options so you’ll find the right solution at the right price.
Knowledgeable and respectful workers who ensure both your own comfort during the installation process, and lasting comfort from your home systems.
Outstanding service, communication, and follow-up, so your home is comfortable now and for years to come.
Get an electrical estimate in Des Moines
A Sumner-based coordinator will book a licensed electrician, and you get a written price and permit plan before work starts.
Get an estimate
A Sumner-based comfort advisor will call you to set up your visit.