Locally-owned since 1977 • Licensed, bonded and insured in Washington (WA Contractor Reg. #HOMECCA785BD) • WA Electrical Contractor Lic. #HOMECCA782DC • NATE-certified technicians • Carrier Factory Authorized Dealer • Mitsubishi Electric Diamond Dealer • Lennox Premier Dealer
Cooling for Silverdale homes, from Old Town to the Kitsap Mall area
Silverdale is an unincorporated community at the north end of Dyes Inlet in Kitsap County. Homes range from older houses near Old Town and the inlet to newer subdivisions and townhomes around the Kitsap Mall and the SR 3 and SR 303 corridor. Many were built with no central cooling at all, so most of our Silverdale cooling calls are one of three things: fixing an existing AC or heat pump, adding cooling to a house that never had it, or replacing an older system with a heat pump that heats and cools.
Our Bremerton branch, about 9 miles southeast, serves Silverdale for air conditioning repair, heat pump installation and ductless mini-splits. Call (425) 645-0404 or send the form, and a comfort advisor will set up the visit.
What cooling costs in Silverdale
These figures are published estimates, not Home Comfort Alliance prices. We give a written price after we see the home.
| Job | Typical range | Source |
|---|---|---|
| AC repair | $100 to $3,000, about $350 average | Angi, HVAC repair costs, 2026 data |
| New central AC, Seattle area | $5,098 to $9,785, about $7,377 average | Angi, Seattle AC replacement costs, updated August 2026 |
| Ducted heat pump, Seattle area | About $10,218 average; $3,160 to $20,000 by efficiency tier | Angi, Seattle heat pump installation costs, updated July 2026 |
| Single-zone ductless mini-split | $2,222 to $5,555 | Angi, Seattle mini-split costs, 2026 data |
The biggest swings come from system size, whether ducts exist and are usable, the electrical work needed for a new 240-volt circuit, and the efficiency rating you choose (SEER2 for cooling, HSPF2 for heating). Estimates for new systems are free; repair visits carry a trip fee that we tell you before we come out.
Central AC, heat pump or ductless?
In a climate where heating matters far more than cooling, the question for most Silverdale owners is not just “which air conditioner” but “which system does both jobs.”
- Central AC added to a gas furnace. Uses the furnace’s ducts and blower. It cools only, so the furnace still carries all the heating.
- Ducted heat pump. Replaces the AC and heats most of the year. It pairs well with an electric furnace, which becomes the backup.
- Dual fuel. A heat pump teamed with a Cascade gas furnace. The heat pump cools in summer and heats in mild weather; gas takes over on the coldest days.
- Ductless mini-split. For homes with baseboard heat and no ducts, or for a bonus room, a loft or an upstairs that runs hot.
A heat pump costs more than a cooling-only AC, but it can lower heating bills too, and it is the only option on this list that qualifies for PSE’s heat pump rebates.
Rebates for Silverdale heat pumps
Silverdale gets its electricity from Puget Sound Energy and its natural gas from Cascade Natural Gas (Kitsap Economic Development Alliance, infrastructure). That matters for rebates:
- Homes that heat with electric baseboards, wall heaters or an electric furnace can qualify for PSE’s rebate for switching to a heat pump: $1,500, plus up to $2,400 more through Efficiency Boost for income-qualified households (PSE electric resistance to heat pump rebate).
- Cascade Natural Gas lists no rebate for heat pumps or dual-fuel systems; its rebates cover gas furnaces rated 95% AFUE or higher installed on or after 15 March 2026 (Cascade Natural Gas residential rebates).
- PSE’s hybrid heat pump rebate is for PSE gas customers, so it does not apply to Cascade gas homes in Silverdale.
Rebate rules change during the year. We confirm what applies to your home at the estimate and fill in the contractor section of the paperwork.
Get an estimateA comfort advisor will call you to set up your visit.
Signs your AC or heat pump needs repair
- Warm air from the vents while the outdoor unit runs.
- The outdoor fan does not spin, or the unit hums without starting (often a capacitor or contactor).
- Ice on the refrigerant lines or the indoor coil.
- Water around the indoor unit or a full condensate pan.
- The breaker trips when cooling starts.
- Short cycling: the system starts and stops every few minutes.
- A heat pump stuck in defrost, or steaming heavily all day in winter.
Before you call, check the thermostat mode and setpoint, replace a dirty filter, and make sure both breakers (indoor and outdoor) are on. If the coil is iced, switch cooling off and run the fan only until it thaws. Low refrigerant always means a leak, and topping it up without finding the leak just delays the next failure.
Sizing and installation
A system that is too big cools the house fast, shuts off, and leaves it clammy. One that is too small runs all afternoon on the hottest days. We size from a room-by-room load calculation that accounts for insulation, windows, orientation and the ducts, not from the size of the old unit.
On a ducted install we also check static pressure and duct leakage, because a new heat pump on undersized or leaky ducts will not deliver its rated efficiency. On ductless jobs we plan where each head goes, where the line set runs outside, and where the outdoor unit sits so it has clearance for airflow and is off the ground where rain and debris collect.
Spring tune-ups
Schedule cooling maintenance in April or May, before the first warm stretch. A visit covers:
- Cleaning the outdoor coil and clearing leaves and moss from the unit.
- Testing the capacitor, contactor and fan motor.
- Checking refrigerant pressures and temperature split.
- Clearing the condensate drain and checking the pan.
- Checking the thermostat and, on heat pumps, the reversing valve and defrost controls.
Heat pumps work year-round, so we also recommend a fall check before heating season.
Hot upstairs rooms and smoky summer days
The most common cooling complaint we hear is an upstairs that sits several degrees warmer than the main floor. Heat rises, ducts to the second floor are often long and undersized, and rooms over a garage or under a low roof pick up heat all afternoon. Fixes range from balancing dampers and adding a return, to a variable-speed system that runs longer at low speed, to a single ductless head in the worst room.
Summer wildfire smoke is the other reason people add cooling: with the windows shut, a closed house heats up fast. A ducted system with a MERV 13 filter, or a ductless unit plus a portable HEPA purifier, keeps the house cool and cleaner while the windows stay closed. Ask us about filter upgrades when we quote the system.
Permits and inspections in unincorporated Kitsap County
Because Silverdale is not a city, permits come from Kitsap County rather than a city hall. A new AC, heat pump or mini-split needs a residential mechanical permit from Kitsap County Department of Community Development (Kitsap County DCD, residential mechanical and plumbing permit form). New wiring for the outdoor unit is permitted through Washington L&I. We pull the permits, schedule the inspections and meet the inspector. Like-for-like repairs do not need a permit.
Warranty and Home Comfort Club
We support the manufacturer’s warranty on covered equipment parts, and we stand behind our air conditioning and heat pump installations with a 1-year labor warranty from installation.
Join our Home Comfort Club, a monthly membership starting at $15 a month, and a new system we install gets extended labor coverage for as long as your membership stays active, up to 5 years from installation. Ask your technician or comfort advisor for the current plan details.
Silverdale air conditioning FAQ
What does AC repair cost in Silverdale?
National data puts most HVAC repairs around $350, with a range from about $100 to $3,000 (Angi, 2026). We give a written price after diagnosis.
Should I get central AC or a heat pump?
If you have an electric furnace or baseboards, a heat pump usually makes more sense because it also heats and can qualify for PSE rebates. With a Cascade gas furnace, central AC or a dual-fuel heat pump both work.
Can you add cooling to a house with no ducts?
Yes. A ductless mini-split needs only a small hole in the wall for the line set, and each indoor head gets its own control.
Who issues cooling permits in Silverdale?
Kitsap County DCD issues the mechanical permit, and Washington L&I covers new electrical work. We handle both.
Why is my heat pump blowing warm air in summer?
Common causes are a thermostat set to heat, a failed capacitor, a stuck reversing valve or low refrigerant from a leak. A technician can test each one.
How long does an AC or heat pump installation take?
Most single-system installs take one to two days. Permits and inspection are scheduled separately.
What warranty comes with your work?
We support the manufacturer’s warranty on covered equipment parts, and our labor warranty covers installations for 1 year from installation. Home Comfort Club members (monthly membership starting at $15 a month) with a new system installed by Home Comfort Alliance get extended labor coverage for as long as their membership stays active, up to 5 years from installation.
Why Choose Home Comfort Alliance in Silverdale?
Your Comfort is Our Promise
We promise...
Reliable heating, air conditioning, plumbing and electrical service, all from one trusted company.
To educate and guide you through your options so you’ll find the right solution at the right price.
Knowledgeable and respectful workers who ensure both your own comfort during the installation process, and lasting comfort from your home systems.
Outstanding service, communication, and follow-up, so your home is comfortable now and for years to come.
Get a cooling estimate in Silverdale
A Bremerton-based comfort advisor will measure your home and give you written options, PSE rebate help and financing choices.
Get an estimate
A Bremerton-based comfort advisor will call you to set up your visit.