





Locally-owned since 1977 • Licensed, bonded and insured in Washington (WA Contractor Reg. #HOMECCA785BD) • WA Electrical Contractor Lic. #HOMECCA782DC • NATE-certified technicians • Carrier Factory Authorized Dealer • Mitsubishi Electric Diamond Dealer • Lennox Premier Dealer
Most HVAC problems start with four things you can check safely: the thermostat, the breaker or service switch, the air filter, and the condensate switch. If those are fine, or you smell gas, see water near wiring, or hear grinding, stop and call a technician. This guide matches each symptom to safe checks, our detailed guide and the right repair page.
Call (425) 645-0404 or book online. Ready to book? See HVAC repair.
Have the model and serial number from the unit's label ready when you call.
| Symptom | Safe check | Call a pro when | Read more or book |
|---|---|---|---|
| Furnace blowing cold air | Thermostat on HEAT, fan on AUTO; filter; wait out the startup delay | Still cold after a few minutes, or clicks with no flame | Furnace blowing cold air; furnace repair |
| Furnace won't light | Thermostat, breaker, service switch, panel door closed | It tries to light and fails | Bad furnace ignitor signs; furnace repair |
| Furnace short cycling | Filter; open vents; thermostat placement | It cycles every few minutes after a filter change | Furnace short cycling; furnace repair |
| Furnace won't turn on | Thermostat, breaker, service switch, panel door closed | The breaker trips again | Furnace won't turn on; furnace repair |
| Furnace keeps running | Fan set to AUTO, not ON | Burners keep firing past the set point | Furnace keeps running; furnace repair |
| Furnace smells | A dusty smell on first use of the season usually fades | Gas, burning plastic or an electrical smell | Furnace smells: normal or dangerous; gas smell |
| Furnace noises | Note the sound and when it happens | A bang at ignition, grinding or screeching | Heater noises; furnace repair |
| No heat in cold weather | All four safe checks | Any check fails: a qualifying emergency | No-heat situations; emergency furnace repair |
| Heat pump blowing cold air | Mode HEAT; steam and a short pause can be the defrost cycle | Cold air for long periods, or aux heat always on | Heat pump blowing cold air; heat pump repair |
| Heat pump iced up | Clear snow and debris around the outdoor unit; never chip ice | Solid ice that stays after defrost | Heat pump frozen; heat pump repair |
| Heat pump not working | Breaker and outdoor disconnect; thermostat | Stopped heating in cold weather | Heat pump isn't working; after-hours heat pump repair |
| Mini-split blinking or dripping | Note the code; rinse the filters | The code returns or water keeps dripping | Ductless mini-split repair |
| Water near the indoor unit | Drain pan, float switch, filter | Water keeps returning, or oily residue | Refrigerant leak or condensation; AC repair |
| AC not cooling | Thermostat on COOL, filter, outdoor unit clear | Ice on the lines, or warm air after the checks | AC not cooling; AC repair |
| AC noises | Note the sound | Buzzing outdoor unit or grinding | AC noises; AC repair |
| Thermostat blank or ignored | Batteries, breaker | No response after a reset, or wiring problems | HVAC repair |
A furnace can blow cool air for a short time at startup before the blower delay ends; that is normal (Carrier). If it keeps blowing cold, check the thermostat, the filter and the service switch, then look for clicking with no flame, which often points to the ignitor or flame sensor. Repeated short cycles usually start with a dirty filter or blocked vents. Our furnace repair page lists repair prices and how a visit works.
In our damp, near-freezing winters, a heat pump's outdoor unit frosts up and runs a defrost cycle; you may see steam and hear the fan stop for a few minutes. That is normal. Solid ice that stays, long periods of cold air, or backup heat that never shuts off are not. Ductless systems have their own checks: see mini-split repair. For cold-weather performance, read about cold-climate heat pumps.
If the AC runs but doesn't cool, check the thermostat, the filter and the outdoor unit for leaves or debris. Ice on the refrigerant lines, water around the indoor unit or a buzzing outdoor unit are signs to turn it off and call. See AC repair.
| Fee | Price |
|---|---|
| Dispatch fee | $119 |
| Standard diagnostic | $72 |
| Deeper diagnostic | $130 |
| After-hours dispatch fee, qualifying emergencies | $330 (instead of the $119) |
Fees are listed separately. You get a written, upfront price before any repair begins, and our trucks are fully stocked, so most repairs can be handled on the spot. Repair cost guides: furnace repair cost and heat pump repair cost.
Get an estimateA comfort advisor will call you to set up your visit.
If your system is older and repairs keep adding up, compare the repair price with a replacement. Read furnace repair vs replacement or heat pump repair vs replace, or get a price range for a new system in about 30 seconds with our instant quote tool.
Yearly maintenance catches dirty burners, weak parts and clogged drains before they fail. A tune-up is $230, or $180 for Home Comfort Club members (HVAC maintenance, membership plans).
In September 2026 a Lake City homeowner called about water leaking near the furnace. The technician found that the GFCI outlet powering the condensate pump had tripped, so the pump had stopped draining. He reset it, added an overflow safety switch to the existing pump, which is designed to stop the system before water spills, and tested everything.
If water shows up near your indoor unit, a tripped GFCI outlet on the condensate pump is one of the first things to check.

Check the thermostat mode, set point and batteries, the breaker and the furnace service switch, the air filter, and the condensate drain or float switch. If all four are fine, or you smell gas or see water near wiring, call a technician.
The most common causes are a thermostat set to fan ON instead of AUTO, a dirty filter that makes the furnace overheat and shut its burners off, or an ignition problem. If it still blows cold after you check the thermostat and filter, book a furnace repair.
Yes. Many furnaces start the blower shortly before the air is fully warm, so a short burst of cool air at startup can be normal. Steady cold air is not.
Short cycling usually starts with a dirty filter, closed or blocked vents, or a thermostat in a poor spot. If it keeps cycling every few minutes after you change the filter, a technician should check the flame sensor, limit switch and sizing.
It may be in defrost mode, which can last a few minutes and sometimes shows as steam from the outdoor unit. If it blows cold for long periods, or the backup heat runs all the time, book a heat pump repair.
Light frost and steam during a defrost cycle are normal in our damp winters. Solid ice that stays on the outdoor unit after defrost is not, so call us and don't chip at the ice.
Air conditioners, heat pumps and high-efficiency furnaces make condensate water that drains away. A clogged drain line, a full pan or a failed condensate pump can make it overflow. Turn the system off if water is near wiring and call for a repair.
Leave the house right away and don't switch anything on or off. From outside, call PSE at 1-888-225-5773 or 911, or Cascade Natural Gas at 888-522-1130 if Cascade is your gas utility.
Get everyone outside to fresh air, call 911 if anyone feels unwell, and have the fuel-burning appliances checked before you use them again.
A visit has a $119 dispatch fee, and diagnostics are $72 for a standard diagnostic or $130 for a deeper one, listed separately. You get a written, upfront price before any repair begins.
No heat in cold weather is a qualifying emergency. Heating and cooling technicians work during business hours and are available after hours for qualifying emergencies, with a $330 after-hours dispatch fee instead of the $119.
Sources: ENERGY STAR maintenance checklist; PSE natural gas leaks; EPA carbon monoxide (all read October 27, 2026); Home Comfort Alliance service prices (September 2026).

Tell us what you need, and our team will set up a repair visit with a written, upfront price.
Get an estimate
We will call you to set up the visit.