





Locally-owned since 1977 • Licensed, bonded and insured in Washington (WA Contractor Reg. #HOMECCA785BD) • WA Electrical Contractor Lic. #HOMECCA782DC • WA Plumbing Contractor Lic. #HOMECCA751QG • NATE-certified technicians • Carrier Factory Authorized Dealer • Mitsubishi Electric Diamond Dealer • Lennox Premier Dealer
Home Comfort Alliance replaces tank, tankless and heat pump water heaters in Mill Creek from our Everett branch on Everett Avenue. Replacement estimates are free, we pull the required permits for every installation, and you get up to $300 off water heater installation.
Mill Creek runs on Snohomish County PUD power, and the PUD pays up to $1,000 back when a qualifying heat pump water heater takes over from your old unit. We help you file the utility rebate claim.
Curious what yours might run? Our online water heater quote gives a starting figure in a few clicks, and a licensed plumber confirms it at your home. Call (425) 645-0404 to set up the visit.
Start with where the trouble sits. A thermostat, heating element, gas valve or relief valve can fail on a tank that is otherwise in good shape, and swapping that one part is usually the sensible call. A tank that leaks through its own wall cannot be patched, and no repair will hold for long.
Your plumber checks the unit, explains which side of that line it falls on, and prices any repair before work begins. If a part fix makes sense, our Mill Creek plumber team handles it, and you can read more on water heater repair.
Most houses and townhomes in this planned city went up between the 1970s and the 2000s, and their heaters tend to sit in a garage corner or a small interior closet. That location shapes the choice as much as the fuel does.
| Type | Fuel | Good fit | Rebate today |
|---|---|---|---|
| Tank | Gas or electric | Direct swap in a garage or closet | None listed |
| Tankless | Gas or electric | Wall mount that frees floor space; gas units need venting | None listed |
| Heat pump | Electric | Garages and roomy utility spaces with open air around the unit | Up to $1,000 from Snohomish County PUD |
A heat pump model pulls warmth from the surrounding air, so a tight townhome closet can starve it. In those spots a tank or tankless unit is often the better match. Compare options on our water heaters page or read about tankless installation.
Washington code sizes a tank by its first-hour rating, the amount of hot water it can deliver in a busy hour.
The city's "Do I Need a Permit" flyer lists water heater replacement and gas piping as work that needs a permit. Any electrical permit comes from the Washington State Department of Labor & Industries instead of the city.
Mill Creek takes building, mechanical and plumbing applications through its OpenGov portal. The Permit Counter is in City Hall North, 15720 Main Street, Suite 110A, phone 425-551-7254, with walk-in help Monday to Thursday from 9 AM to noon. Homes with a Mill Creek mailing address but outside city limits get their permits from Snohomish County Planning and Development Services.
We pull the required permits for every installation.
Your final price depends on the type and size you pick, venting, any gas or electrical changes and where the heater sits. You can start with the online water heater quote, and the plumber confirms the number in writing at your home.
| Service | Price |
|---|---|
| Replacement estimate | Free |
| Plumbing dispatch | $99; repair quoted on site |
| Tank water heater service | $230, or $150 added to a furnace, AC or heat pump service |
| Tankless service (no flush) | $230 |
| Tankless flush (tankless maintenance) | $429 |
Prices as of September 2026.
Regional estimate, not our price: Angi puts the average cost to install or replace a water heater in Everett, WA at $1,556, with typical jobs between $1,204 and $2,134 (read November 2026). Our water heater cost guide covers what moves the number.
Current offer: Up to $300 off water heater installation. Details on our special offer page.
Financing through Salal Credit Union or Synchrony starts at $179/month* (financing).
*Financing through Salal Credit Union or Synchrony, subject to credit approval. Rates, terms and monthly payments depend on the amount financed, the plan and your credit. 0% interest options are available to qualifying customers. See lender for full terms.
Get an estimateA comfort advisor will call you to set up your visit.
Mill Creek homes buy power from one utility and gas from another, and only one of them pays on water heaters.
Checked on snopud.com and pse.com, November 2026.
Home Comfort Alliance is listed in Snohomish County PUD's water heater contractor network. We help you file the utility rebate claim. See every program on our Snohomish PUD rebates page.
Two districts deliver water inside Mill Creek: Alderwood Water & Wastewater District and Silver Lake Water & Sewer District. The name on your water bill tells you which one serves your home.
Smell gas? Leave the house first. Then call 911 and Puget Sound Energy at 1-888-225-5773.
If the tank is leaking, close the cold water valve above it.
In August 2026 a Mill Creek homeowner called because water was showing up under their tankless water heater, two months after we had serviced it. Our plumber found beads of dark, oily water at the bottom of the heat exchanger. The manufacturer’s tech support confirmed that a little condensation there is normal, so we asked the homeowner to keep an eye on it and call us back, with no return trip charge, if water showed up again.

Want to keep the new unit in shape? The plumbing plan in our Home Comfort Club includes an annual plumbing inspection.
We serve homes inside city limits and the unincorporated areas with Mill Creek and 98012 addresses. Nearby, we also replace water heaters in Bothell, Snohomish, Lake Stevens and Edmonds.
For everything else in town, start at our Mill Creek service area page or our plumbing services.
There is no charge for the replacement estimate. What you pay depends on the type and size you choose, venting, any gas or electrical work and where the heater is located. Our online water heater quote gives a starting figure, and a plumber confirms it at your home in writing. Installation includes up to $300 off.
A repair visit carries a $99 dispatch fee, and the plumber prices the repair on site before starting. Tank service costs $230, or $150 when paired with a furnace, AC or heat pump service. Tankless service without a flush is $230, and a tankless flush is $429.
If water is coming through the tank wall, the heater needs replacing, since a tank body cannot be fixed. If a single part such as a thermostat, element or valve has failed on a sound tank, a repair is usually the better value. Your plumber explains which applies before any work.
We do. The city treats a water heater swap as permitted work and processes applications on OpenGov, with a counter at City Hall North. We pull the required permits for every installation and schedule the inspection.
Yes. We work throughout the 98012 area, including unincorporated Mill Creek East. For those addresses the permit comes from Snohomish County Planning and Development Services rather than the city.
Yes. Snohomish County PUD, Mill Creek's electric utility, pays up to $1,000 when a qualifying heat pump water heater replaces an existing water heater. File within 90 days of the invoice; each account gets one rebate every five years (snopud.com, November 2026). We help you file the utility rebate claim.
Not as of November 2026. PSE supplies natural gas in Mill Creek but listed no rebate for gas water heaters. Its heat pump water heater rebate goes only to PSE electric customers, and Mill Creek gets its power from Snohomish County PUD.
Washington's plumbing code calls for strapping in the upper and lower third of every tank. A home with a closed system, such as one with a pressure-reducing valve on the main, also needs an expansion tank. We include what code requires for your house.
Yes. We work in townhomes as well as single-family houses. A heat pump unit needs open air around it, so in a small closet a tank or tankless model may fit better. If you belong to an HOA, ask whether new outside vents need its sign-off first.
Every install comes with a 1-year labor warranty on installations, and we support the manufacturer's warranty on covered parts. We install all major water heater brands.
You can book by phone or online at any time, and we offer the first open visit. Our plumbers work Monday to Friday, 8 AM to 5 PM, with same-day service when possible. While you wait on a leaking tank, shut the cold water valve above it.
Yes. We hold WA Plumbing Contractor Lic. #HOMECCA751QG (residential) and are licensed, bonded and insured in Washington. Financing through Salal Credit Union or Synchrony starts at $179/month*, and qualifying customers can get 0% interest options.
Sources (read November 2026): City of Mill Creek permit flyer; City of Mill Creek permits; City of Mill Creek utilities; Snohomish County PDS permits; Snohomish County PUD heat pump water heater rebate; Snohomish County PUD water heater contractor network; PSE heat pump water heater rebate; PSE gas leak safety; WAC 51-56-0500; Angi, Everett WA water heater install or replace.

Tell us about your current water heater, and our Everett branch will set up a free estimate with a written price before any work begins. Want a price range first? See water heater prices online.
Get an estimate
We will call you to set up the visit.