





Locally-owned since 1977 • Licensed, bonded and insured in Washington (WA Contractor Reg. #HOMECCA785BD) • WA Electrical Contractor Lic. #HOMECCA782DC • NATE-certified technicians • Carrier Factory Authorized Dealer • Mitsubishi Electric Diamond Dealer • Lennox Premier Dealer
Home Comfort Alliance installs and replaces ducted, ductless and hybrid heat pumps in Mill Creek from our Everett branch, with a room-by-room Manual J load calculation and the required permits on every installation.
Approved contractor for Snohomish PUD and PSE
Mill Creek homes get electricity from Snohomish PUD and natural gas from PSE. The PUD rebate comes off your price when electric heat is your primary heat, gas homes can add a heat pump with PSE's hybrid rebate, and there is no federal tax credit in 2026. Most installations take 4 to 10 hours, permits included.
Call (425) 645-0404 or book online. Need a repair instead? See heat pump repair.
Usually, yes. A heat pump heats and cools with one system, and what you heat with today decides the best setup and the rebate.
| What you heat with today | Usual heat pump option | Rebate to check |
|---|---|---|
| Gas furnace (most Mill Creek homes) | Hybrid: a heat pump added to your furnace, or a full switch to a heat pump | PSE $1,500 hybrid; $4,000 if income-qualified and switching off gas |
| Electric furnace | Ducted heat pump on the existing ducts | Snohomish PUD $1,800 or $2,500 |
| Baseboards or wall heaters | Ductless heat pump, or ducted if the home has ducts | PUD rebate for ducted systems only |
| Older heat pump | Ducted replacement sized to the home | PUD rebate when electric heat is primary |
Condos and townhomes near Town Center and along North Creek often suit ductless systems, with the outdoor unit placed for quiet running.
Mill Creek homes get electricity from Snohomish PUD and natural gas from PSE.
| Utility | Amount | Who qualifies |
|---|---|---|
| Snohomish PUD | $1,800 | Ducted heat pump rated 7.5 HSPF2 and 13.8 SEER2 or better, when electric heat is your primary heat; installed by a PUD registered contractor |
| Snohomish PUD | $2,500 | Ducted inverter-driven heat pump rated 8.5 HSPF2 or better; same rules |
| PSE (natural gas) | $1,500 hybrid | PSE gas furnace homes adding a ducted heat pump that switches over at 30°F or lower |
| PSE (natural gas) | $4,000 | Income-qualified PSE gas customers switching to a heat pump; apply within 30 days of install |
The PUD rebate comes off your bill as reduced pricing, and we send the application to the PUD for you. Snohomish PUD lists rebates for ducted heat pumps only today, so ductless systems don't get a PUD rebate. Gas-heated homes don't qualify for the PUD rebate, but PSE's hybrid rebate works for PSE gas customers on PUD power: we have claimed it for Mill Creek homes this year. The federal 25C tax credit ended for equipment installed after December 31, 2025. We are an approved contractor for Snohomish PUD and PSE (Snohomish PUD rebates, all rebates).
We are a Mitsubishi Electric Diamond Dealer, Carrier Factory Authorized Dealer, Lennox Premier Dealer and Quilt dealer, and we service all major brands.
Mill Creek is not listed in Washington's energy code climate table; the heating design temperature for nearby Everett is 21°F (WAC 51-11C-80100). We size every heat pump with an ACCA Manual J load calculation, room by room, rather than matching the old equipment, and we recommend cold-climate heat pumps or a hybrid system where your home needs more margin.
Your price depends on your home's heating and cooling needs, the add-ons you need, how many rooms the system serves and where it's installed. Get a price range in about 30 seconds with our free instant quote tool, then a technician confirms the exact price on a free site visit. More detail: heat pump cost guide.
Regional benchmark, not our price: Angi lists Seattle-area heat pump installations at about $6,667 to $13,852, averaging $10,218 (checked November 2026, Angi).
Financing through Salal Credit Union or Synchrony starts at $179/month* (financing).
*Financing through Salal Credit Union or Synchrony, subject to credit approval. Rates, terms and monthly payments depend on the amount financed, the plan and your credit. 0% interest options are available to qualifying customers. See lender for full terms.
Get a free estimateAn in-home visit and a written, upfront price before any work begins.
Inside city limits, the City of Mill Creek issues the permit through MyBuildingPermit, and Washington L&I issues the electrical permit (L&I city list). Addresses outside city limits, such as Mill Creek East, go through Snohomish County. We pull the required permits for every installation.
A heat pump needs a dedicated circuit, and some older panels lack the space or capacity. We check your panel on the estimate visit, and our licensed electricians handle any upgrade (panel upgrades, WA Electrical Contractor Lic. #HOMECCA782DC).
Signs it is time: frequent repairs, weak heat in cold weather, rising bills, or a system that uses R-22 refrigerant. If electric heat is your primary heat, check whether your home qualifies for a Snohomish PUD rebate before you choose a system. Not sure? Read repair or replace a heat pump (heat pump replacement).
A 3-year Comfort Shield labor warranty on new installations, kept active with yearly maintenance. First-year maintenance is included. After that, a heat pump tune-up is $308 to $399, depending on the type of system, or from $240 for Home Comfort Club members. Home Comfort Club members with a new system installed by Home Comfort Alliance get extended labor coverage for up to 5 years from installation. Home Comfort Club plans are $15 a month per trade or $30 a month for all three (membership plans).
In September 2026 we added a heat pump to a Mill Creek home that heats with PSE natural gas, as a hybrid system: a new Lennox furnace and refrigerant coil, a filter slot at the furnace, a new thermostat, and refrigerant lines routed through the garage on the existing electrical circuit. The heat pump now handles the cooling and most of the heating, and PSE paid its $1,500 hybrid rebate.



We install heat pumps across Mill Creek (98012), including Town Center, North Creek, Thomas Lake and the Country Club area, from our Everett branch. Nearby: heat pumps in Lake Stevens, heat pumps in Bothell, heat pumps in Edmonds and heat pumps in Snohomish.
Your price depends on your home's heating and cooling needs, the add-ons you need, how many rooms the system serves and where it's installed. Get a price range in about 30 seconds with our free instant quote tool, then a technician confirms the exact price on a free site visit. For reference, Angi puts the Seattle-area average at $10,218, with a typical range of $6,667 to $13,852 (regional estimate, checked November 2026), before rebates.
Mill Creek homes get electricity from Snohomish PUD. The PUD pays $1,800 for a ducted heat pump (7.5 HSPF2 and 13.8 SEER2 or better) or $2,500 for a ducted inverter-driven heat pump (8.5 HSPF2 or better), when electric heat is your primary heat and a PUD registered contractor installs it. Amounts checked November 2026.
We are an approved contractor for Snohomish PUD, so the rebate comes off your bill as reduced pricing and we send the application to the PUD for you.
The PUD rebate needs electric heat as your primary heat, so gas-heated homes don't qualify for it. You can add a heat pump to your gas furnace as a hybrid system, and PSE pays $1,500 to its natural gas customers for that, even when Snohomish PUD supplies your electricity. Income-qualified PSE gas customers who switch fully to a heat pump can get $4,000.
Snohomish PUD lists rebates for ducted heat pumps only today. We still install ductless systems for homes without ducts, condos, additions and rooms the ducts don't reach, and we check the PUD's current list before we quote.
No. The federal 25C tax credit ended for heat pumps installed after December 31, 2025. Utility rebates are still available, and we check every program you qualify for.
Yes. Inside city limits the City of Mill Creek issues the permit through MyBuildingPermit, and Washington L&I issues the electrical permit. Addresses outside city limits, such as Mill Creek East, go through Snohomish County. We pull the required permits for every installation.
Most heat pump installations take between 4 and 10 hours, depending on the system type and how many systems we install.
Yes, when it's sized right. The heating design temperature for nearby Everett is 21°F under the Washington State Energy Code. We size every system with a room-by-room Manual J load calculation and set backup heat to come on only when it's needed.
Sometimes. A ducted heat pump needs its own circuit, so we check your panel at the free estimate. If it needs an upgrade, our licensed electricians handle it (WA Electrical Contractor Lic. #HOMECCA782DC).
If it's older, uses R-22 or needs frequent repairs, replacing it usually makes more sense. Our technician can price both, and replacement estimates are free.
A 3-year Comfort Shield labor warranty on new installations, kept active with yearly maintenance. First-year maintenance is included. After that, a heat pump tune-up is $308 to $399, depending on the type of system, or from $240 for Home Comfort Club members. Home Comfort Club members with a new system installed by Home Comfort Alliance get extended labor coverage for up to 5 years from installation.
Sources: Snohomish PUD rebates (read November 2, 2026); PSE hybrid heat pump rebate; Washington L&I city electrical list; WAC 51-11C-80100 design temperatures; Angi, Seattle heat pump cost.

Tell us what you need, and our Sumner team will set up an installation estimate or a repair visit with a written, upfront price.
Get an estimate
We will call you to set up the visit.