Furnace Repair in Kirkland, WA
Furnace repair for Kirkland homes from our Redmond branch next door: after-hours emergency heating service, same-day visits when possible, published repair prices and an upfront quote before any work begins.
Locally-owned since 1977 • Licensed, bonded and insured in Washington (WA Contractor Reg. #HOMECCA785BD) • NATE-certified technicians • Carrier Factory Authorized Dealer • Mitsubishi Electric Diamond Dealer
Furnace repair in Kirkland, at a glance
Home Comfort Alliance fixes gas and electric furnaces in Kirkland from our Redmond branch, just across the city line. We publish our service prices below, send heating technicians after hours for no-heat calls, and offer same-day visits when possible. A NATE-certified technician finds the cause and gives you an upfront price before any work begins. Repair visits carry a $119 dispatch fee, and the standard diagnostic is $72.
Call (425) 645-0404 or use the form at the end of this page. Weighing a new heating system instead? See our Kirkland heating contractor page.
If you smell gas, leave right away, leave switches alone, and call 911 or Puget Sound Energy, which provides Kirkland's natural gas, at 1-888-225-5773 from outside (PSE gas leak steps). Call us when the utility gives the all clear.
Kirkland furnace problems we fix every week
- A furnace that sounds like it is straining, then shuts down without heating.
- Burners that light and drop out, often a dirty flame sensor or a blocked pressure switch tube.
- A blower that runs constantly or not at all.
- Uneven heat between floors, or rooms that never reach the set temperature.
- A thermostat that is blank, unresponsive or not talking to the furnace.
- Loud starts, rattles and whistles from the cabinet or the ducts.
Checks to try before booking
- Set the thermostat to HEAT and a few degrees above room temperature.
- Make sure the breaker and the furnace switch are on.
- Replace a dirty filter.
- Look at the condensate drain on a high-efficiency furnace; a full trap or kinked tube can stop the heat.
No luck? Call us and we will take it from there.
Gas, electric and high-efficiency furnaces in Kirkland
Kirkland's electricity and natural gas both come from Puget Sound Energy. We repair standard and high-efficiency gas furnaces, electric furnaces, and furnaces paired with heat pumps, on every major brand.
| Furnace | What usually fails | Tip |
|---|---|---|
| High-efficiency gas (plastic vent pipes) | Pressure switch and its tubing, condensate trap and drain, inducer motor | Annual maintenance keeps the drain and pressure ports clear. |
| Standard gas | Ignitor, flame sensor, limit switch, control board | We check for carbon monoxide on every gas visit. |
| Electric | Elements, sequencers, breakers | A heat pump is the efficient upgrade for electric heat. |
After-hours furnace repair in Kirkland
Call (425) 645-0404 any time. Our heating technicians take after-hours no-heat calls in Kirkland for a $330 after-hours fee, shown on its own line. During business hours, Monday to Friday 8 AM to 5 PM, regular rates apply and we offer same-day visits when there is room in the schedule.
Keep the household warm safely while you wait: close off unused rooms, keep space heaters clear of bedding and curtains, and never use a gas range for heat. Our emergency furnace repair page has more.
Kirkland furnace repair prices
A typical furnace repair in our region costs $139 to $544, with an average of $341, per Angi's Seattle-area figures (a regional estimate from August 2026, not our price). Our own service prices are listed in full below, so you know the visit cost before anyone arrives.
| Seattle-area furnace repair (Angi, Aug 2026) | Range |
|---|---|
| Typical repair | $139 to $544 (average $341) |
| Flame sensor | $160 to $270 |
| Ignitor | $160 to $540 |
| Control board | $220 to $650 |
| Blower motor | $160 to $2,160 |
For a part-by-part breakdown and what changes the price, see our furnace repair cost guide.
Our Kirkland furnace repair prices
| Home Comfort Alliance item | Price |
|---|---|
| Dispatch (trip) fee | $119 |
| Standard diagnostic | $72 |
| Deeper diagnostic (when needed) | $130 |
| After-hours fee | $330 |
| Ignitor replacement | $353 to $821 |
| Thermostat replacement | $299 to $1,840 |
| Furnace tune-up | $230 ($180 for Home Comfort Club members) |
Prices as of September 2026. Each fee is listed on its own line; the two diagnostic fees are alternatives, not added together.
Current offer: $50 off HVAC service or repair (special offers). A larger repair can be financed through Salal Credit Union or Synchrony, with plans from $179/month* and 0% interest options for qualifying customers (financing). Home Comfort Club members (from $15 a month) get priority scheduling, discounted repair rates and a $180 tune-up (membership plans).
Book a furnace repairYou approve a written, upfront price before any work begins.
*Financing through Salal Credit Union or Synchrony, subject to credit approval. Rates, terms and monthly payments depend on the amount financed, the plan and your credit. 0% interest options are available to qualifying customers. See lender for full terms.
Should you repair or replace a Kirkland furnace?
Repair a furnace under about 15 years old when one part has failed. Price a replacement when it is older than 15 to 20 years, keeps breaking, or has a cracked heat exchanger. A quick guide is the $5,000 rule: if the furnace's age times the repair cost is more than $5,000, compare both options.
Kirkland is one of the six Energy Smart Eastside cities, so a replacement heat pump can earn a $1,000 instant rebate (Mitsubishi, Bryant/Carrier or Day & Night through a network contractor) and, for qualifying moderate-income homes going fully electric, a $5,000 bonus, up to $6,000 combined. PSE pays $1,500 toward a ducted heat pump paired with an existing PSE gas furnace, or up to $2,400 with its income-based Efficiency Boost. We checked these amounts on 9 October 2026 and are approved for both programs; the federal 25C tax credit ended on 31 December 2025.
See furnace replacement in Kirkland or get a quick range from the instant quote tool.
How a Kirkland furnace repair works
- Book by phone or online, 24/7.
- A technician from our Redmond branch arrives in a stocked van.
- We test the system: codes, ignition, draft and pressure switches, drains, airflow and carbon monoxide.
- You receive a written, upfront price and approve it first.
- We repair and test through complete heating cycles.
- You get notes on what we found and what to watch.
A recent Kirkland furnace repair: north Kirkland
In September a north Kirkland homeowner called because the gas furnace sounded like it was struggling and the house had no heat. The furnace was a Lennox about four years old. Our technician found a plugged pressure switch port; when that port blocks, the furnace cannot prove a safe draft and shuts the burners down. He cleared it, performed a full maintenance tune-up and left the furnace running properly, then recommended annual maintenance to catch this kind of blockage before it causes another no-heat call.
From our September 2026 service records; customer details are kept private.
What you get with Home Comfort Alliance
- A NATE-certified technician and an upfront, written price before any work begins.
- After-hours heating service in Kirkland for no-heat emergencies.
- Licensed, bonded and insured in Washington (WA Contractor Reg. #HOMECCA785BD).
- Every major furnace brand serviced. We are a Carrier Factory Authorized Dealer and a Lennox Premier Dealer.
- BBB Accredited Business since 2002, ACCA member, Best Pick 2025 and 2026.
- Locally owned since 1977.
Where we repair furnaces in Kirkland
We serve all of Kirkland, including Juanita, Finn Hill, Totem Lake, Evergreen Hill, Highlands, Norkirk, Market, Moss Bay, Lakeview, Central Houghton, Everest and both Rose Hill neighborhoods, plus nearby Redmond, Bellevue, Bothell, Woodinville and Kenmore.
The City of Kirkland requires a mechanical permit for furnace installation or replacement and issues its own electrical permits, with applications filed through MyBuildingPermit.com. We pull the required permits for every installation.
Kirkland furnace repair FAQ
Who does furnace repair in Kirkland, WA?
Home Comfort Alliance repairs gas and electric furnaces across Kirkland from its Redmond branch. Call (425) 645-0404; phones are answered 24/7.
How much does furnace repair cost in Kirkland?
Most repairs cost $139 to $544, averaging $341 (Angi Seattle-area estimate, August 2026). Our dispatch fee is $119 and the standard diagnostic is $72, listed separately, and you approve the repair price first.
Do you offer emergency furnace repair in Kirkland?
Yes. Our heating technicians take after-hours no-heat calls in Kirkland, with a $330 after-hours fee.
What is a furnace pressure switch?
It is a safety switch that confirms the inducer fan is pulling exhaust out before the burners light. If its tube or port is blocked, or the vent is restricted, the furnace will not heat. Cleaning or replacing it is a common repair.
Why does my furnace sound like it is struggling?
Straining or humming often points to a blocked pressure port, a failing inducer motor, a clogged filter or a dirty blower wheel. Turn it off and book a visit before the part fails completely.
Does a high-efficiency furnace need different repairs?
High-efficiency gas furnaces add a condensate drain, a second heat exchanger and plastic vent pipes. Blocked drains and pressure ports are common no-heat causes, and annual maintenance prevents most of them.
Can you repair my furnace the same day in Kirkland?
Same-day visits are available when the schedule allows, and our vans carry the parts that fail most often.
How long should a furnace last?
Most gas furnaces last about 15 to 20 years with regular maintenance. Past that, compare repair and replacement using the $5,000 rule.
Are there rebates for a new heating system in Kirkland?
Kirkland is an Energy Smart Eastside city: a $1,000 instant heat pump rebate plus a $5,000 bonus for qualifying moderate-income homes going fully electric, and PSE pays $1,500 for a heat pump added to a PSE gas furnace (October 2026). Repairs do not qualify.
Do I need a permit to replace a furnace in Kirkland?
Yes. The City of Kirkland requires a mechanical permit to install or replace a furnace. We pull the required permits for every installation.
Which Kirkland neighborhoods do you cover?
All of Kirkland, including Juanita, Finn Hill, Totem Lake, Evergreen Hill, Highlands, Norkirk, Market, Moss Bay, Lakeview, Central Houghton, Everest and Rose Hill.
Sources (checked October 9, 2026): Angi, Seattle furnace repair cost (Aug 2026); Puget Sound Energy, detect a gas leak; Energy Smart Eastside, homeowner rebates; PSE, hybrid heat pump rebate; City of Kirkland, utilities.
Why Choose Home Comfort Alliance in Kirkland?
Your Comfort is Our Promise
We promise...
Reliable heating, air conditioning, plumbing and electrical service, all from one trusted company.
To educate and guide you through your options so you’ll find the right solution at the right price.
Knowledgeable and respectful workers who ensure both your own comfort during the installation process, and lasting comfort from your home systems.
Outstanding service, communication, and follow-up, so your home is comfortable now and for years to come.
Book a furnace repair in Kirkland
Tell us what your furnace is doing. A heating technician from our Redmond branch will diagnose it and give you a written, upfront price before any work begins.
Request furnace repair
Our team will call you to set up your visit. For no heat after hours, call (425) 645-0404.